3rd Wave OS version 1.1a

bug fixes since version 1.0:
 - fix for midi program change via midi din
 - fix for mod source and destination button hold
 - fix for elusive stuck notes
 - fix for tempo drifts in sequencer and arp
 - fixes for midi clock sync + song position pointer
 - improvements to volume potentiometer to have smooth fade out
 - improvements to analog waveforms on low notes
 - part clear in sequencer
 - envelope repeat
 - improvements to velocity precision for 3rd Wave keyboard - velocity curve still needs work
 - improvements to sawtooth analog model
 - improvements to potentiometer precision
 - synthplex update: slightly wider dead zone for detent pots + fix for usb drive not mounting on latest Mac OS on certain hubs
 - unison + arp settings now editable per part
 - global setting MIDI multitimbral mode to control parts on separate MIDI channels
 - reverse mode for osc key to waves setting, to replicate ppg behavior
 - improvements to Circuit Drift: envs, filters, fine tuning follow a set of repeatable changes + other suggestions
 - fixes for multitimbral playback in sequencer
 - fix to spatial panning wraparound to always get movement
 - fix for arp start with midi sync
 - fix for setting mod destinations per part
 - fix for note hang when disconnecting sustain pedal in certain configs
 - fix for midi active sensing message, Yamaha Montage issue
 - fix for issue in analog waveforms recently introduced, especially in A04, supersaw waveform
 - fix for envelope sustain modulation
 - fixes for curcuit drift, analog filter cutoff and resonance per part
 - fix for sawtooth pulse width
 - new velocity and pressure curve/settings
 - fix for amp env + velocity settings
 - fixes for wavetable maker crashing bug after making multiple tables
 - added tenths place decimal for tempo
 - unison chord mode, will not erroneously activate for 1 note + ui update to show part for unison settings
 * Noise input setting honored for wave maker
 * LPF velocity ui now says velocity to cutoff or velocity to env depending on the velo to env setting in LPF misc
 * More unison key assign options for no retriggering + added legato setting
 * Display error messages if failure to read the wav file for wavemaker
 * New ARP latch option for HOLD. With HOLD on and this setting set to "chord", it will replace the notes of the previous chord instead of adding to arpeggio when you play chords
 * Another bug fix for elusive stuck note issue that you may have encountered
 * Bug fix for midi clock sync that was causing issues with effects clock sync setting, was erroneously setting to very low bpm for an instant at the beginning of playback
 * Added display brightness setting in Global menu
 * Added "pass thru" pot mode setting in the Global menu. With pot mode set to pass thru, you have to move the pot past the current saved value before it triggers an update to the setting.
 * fix for wave env release point issues
 
TO LOAD A NEW OS:
1. Connect your 3rd Wave to your computer, (Windows or Mac), via the USB connector on the back of the Synth.
2. Once connected the 3rd Wave will show up as an external drive
3. Copy the "ldr" file into the firmware folder on the 3rd Wave.
4. Once the copy is finished, press the global key on the 3rd Wave and then the left most encoder knob above the display to go to the "Firmware Update" selection
5. Use the second encoder from the left to select "Go"
6. The screen will now show "Firmware file: N/A", it will load the filename after a slight pause or press the refresh button at the bottom of the screen.
7. The display will now show the name of the file that you placed in the firmware folder.
8. Press "OK" at the bottom right.
9. The display will tell you when it is finished updating.
10. Once the display indicates that it is finished, disconnect the USB cable from the synth, re-boot the synthesizer.